42
SOFT 80, SOFT 100 PELLET-BURNING STOVE
Cleaning the vermiculite components
The vermiculite panels do not require any special maintenance. If necessary, they must be dusted gently using a brush
only. To avoid jeopardising their durability, they must not be cleaned using abrasive sponges, wet cloths or the tube of
the ash vacuum device placed directly in contact with it.
Remove the flame separator as shown in the picture (Figures 24 and 25).
To remove the vermiculite components, first remove the outer panels and then the rear panel (Figures 26 and 27).
WARNING: handle the vermiculite panels very carefully as they do not withstand impacts.
To Next Page
Loading...
