7.2 Additional True Double Tracking functions
(V2 Firmware and above)
While we designed our dead-simple-to-use, yet custom AI driven True Double Tracker
Algorithm to be as authentic to the studio doubling tracking recording process as possible, for
those using the TDT post FX Loop or simply wanting more control, there are a couple of hidden
features to help tailor the TDT algorithm to your own taste.
Doubling Timing
This affects the onset detection timing (or tightness) of the AI-driven doubled signal.
To adjust, press and hold the DOUBLING Foot-switch while turning the TDT WIDTH knob. Turn
left (CCW) for tighter timing, right (CW) for looser timing. Centre Detent is ENDGAME’s default
factory position. Once you’ve found your preferred setting, release the DOUBLING Foot-switch
and the Doubling Timing will be stored. The TDT WIDTH knob will return to its normal function
after this process.
Doubling Level
This affects the level of the Doubled signal against the original source.
To adjust, press and hold the FX LOOP Foot-switch while turning the TDT WIDTH knob. Turn left
(CCW) for less doubled signal, right (CW) for more. Centre detent is ENDGAME’s default factory
position. Once you’ve found your preferred setting, release the release the FX LOOP Foot-switch
and the Level will be set. The TDT WIDTH knob will return to its normal function after this
process.
Notes:
These functions require V2 (or higher) of the ENDGAME’s rmware to be installed.
Timing and Level settings are stored in ENDGAME once set and the relevant Foot-switch is
released.
The TDT WIDTH knob physical position will not dictate the Doubler Width until the previously
selected position is passed through.
Back to top
To Next Page
Loading...
