11.3 Stereo Input
KMA ENDGAME Setup example: Stereo Input
If you wish to connect a stereo device – such as a stereo Amp/Cab Sim or synth etc. – directly to
ENDGAME, then you can connect these via the
Stereo FX Loop return.
While this setup will negate the FX Loop, it still allows you to gain benets from all the other
ENDGAME features. This setup also compliments your device with a more comprehensive set of
inputs and outputs, such as dual headphone outlets, Pro level XLR, separate TS/TRS connections,
Bluetooth etc. And it will also turn the FX Loop footswitch into a single-press mute function.
Tone Tip:While for the most accurate performance our custom True Double Tracker algorithm
should be fed with a mono signal, it still has a useful and very pleasing effect on stereo signals. In
the majority of cases, Stereo effects are usually added after the guitar preamp, power amp and
speaker when mixing or recording. However, note that if you wish to use a preferred Stereo Cab/
Amp Sim device, most of these are fundamentally mono internally (only built in simple ambience
or stereo input signals are processed to pass through in stereo), so we do suggest you
experiment with running these kinds of devices in mono directly into the ENDGAME’s input and
use the FX loop for your stereo pedals. This will allow you to get the best benets and tonality
that ENDGAME provides. For this setup, you need to make sure that both FX LOOP POSITION
toggles switches are set to POST.
KMA Machines ENDGAME manual ⋅ firmware version V2 https://kma.specs-and-docs.online/kma_endgame_manual__English.htm
46 von 57 08.01.2025, 14:38
To Next Page
Loading...
