13. Factory Reset
In the event that you wish to return your ENDGAME to its original factory settings, proceed as
follows:
1. Disconnect Power.
2. Make sure both FX Loop Position toggle switches are in the PRE position.
3. Press and hold the DOUBLER Foot-switch and the PWR AMP MODE button.
4. Reapply power to your ENDGAME, while continuing to hold these controls for a few
seconds.
Note: Resetting the product to factory settings deletes any customised loaded Impulse
Responses stored in the on-board User Memory Slots (UA and UB).
Back to top
To Next Page
Loading...
