6. Setting Levels
Stetting the optimum levels of any audio device, otherwise known as Gain Staging, will always
give you the best overall experience. Within ENDGAME, the main INPUT GAIN control with its
premium high impedance circuitry can provide up to +/-24 dB of gain/reduction.
When setting up your external gear with ENDGAME, it is advisable to take some time to ensure
that volume levels for each device in your signal chain are set up correctly.
With the
FX Loop turned off, start by establishing a correct level at the input, using the INPUT
GAIN control. make sure that your loudest possible input signal (from e.g.Distortion, Overdrive,
Fuzz, Octave, Synth, Boost, Compressor or any other device before the main input) is not causing
the red INPUT CLIP LED to illuminate. If the INPUT CLIP LED does light up, reduce the INPUT
GAIN control until the LED is no longer active.
Following this procedure, enable the FX Loop and then work to ensure that your Stereo effects in
their loudest settings are also not causing the INPUT CLIP LED to illuminate. Some stereo effect
units can add gain to signals, dependent on the effect used and their individual settings.
Essentially the goal is to ensure that gain staging is set for optimal usage of all devices within the
signal chain, to get the best out of them and your rig.
Back to top
KMA Machines ENDGAME manual ⋅ firmware version V2 https://kma.specs-and-docs.online/kma_endgame_manual__English.htm
28 von 57 08.01.2025, 14:38
To Next Page
Loading...
