Switch 2 – Impulse Response / Amp Simulation Bypass
Switch 2 disables Ambience, Cab Impulse Response and Power Amp Simulations from the TS/
TRS Outputs. This is perfect for monitoring using regular guitar amps on stage while sending the
full mix to IEM/Headphone and XLR Outputs.
Regardless of the position of Switch 2, the full mix is always sent to the Headphone Outputs.
Switch 2 set to ON
Ambience, Cab Impulse Response and Power Amp Simulations are sent to both the XLR
and TS/TRS Outputs.
Switch 2 set to OFF
Ambience, Cab Impulse Response and Power Amp Simulations are sent to the XLR outputs
only.
For more information, see the
To Next Page
Loading...
