11.4 Rig Doubler
KMA ENDGAME Setup example: Rig Doubler
Utilising the ENDGAME’s ability to create a dual amp setup from a mono signal, try plugging your
instrument into the ENDGAME directly. Then use the left and right channels of the loop for two
separate and complete mono signal chains. These mono signal chains are then summed within
the ENDGAME.
Adding different preamps or amp modellers in each channel can create interesting results, with
the difference in each perceivably adding depth and aural distinction to your overall tone.
Tone Tip:You can also use each side of the FX loop for creative endeavours with mono effects.
Try experimenting by blending different mono delays, reverbs and modulations, creating virtually
unlimited interesting and unique textures for each stereo side of ENDGAME’s output. For this
setup, we also recommend that the FX LOOP POSITION toggles switches are set as follows -
TDT set to PRE and CAB IR set to POST.
To Next Page
Loading...
