11.2 Potential Maximiser
KMA ENDGAME Setup example: Potential Maximiser
There are several Amp Modellers/ Cabinet Simulators on the market that are highly detailed
products with extensive options which are highly customisable via their user interfaces.
Depending on your own personal preference, you can decide whether to use the Celestion®
Cabinet Impulse Responses that are included in ENDGAME or use your preferred existing
simulation device. In that case, run your device into the ENDGAME’s input.
This allows you to use all of the secondary device’s features, while the ENDGAME compliments
these with a more comprehensive set of IO, the TDT Stereo Doubler, the ability to add stereo
effects via the FX loop, Bluetooth, Dual Headphone outputs or all of these at once.
Tone Tip:Traditionally, stereo effects are often added after the guitar preamp, power amp and
speaker when mixing or recording. Sending a “nished” mono signal into the ENDGAME enables
you to create a virtual “mix bus” on your pedal board by adding doubling, then stereo effects to
this setup and complimenting it in the same way as an engineer may do when mixing a recorded
guitar “group”. Remember though that if you do use external cab and power amp simulation, for
the best results you will need to ensure that these options are turned off on ENDGAME, in order
that you are not duplicating the simulations. For this setup, we recommend that both FX LOOP
POSITION toggles switches are set to PRE.
To Next Page
Loading...
