15. Foot-switch Behaviour
(V2 Firmware onwards)
To allow the DOUBLER and FX Loop Foot-switches to be able to be used as secondary function
triggers, these work as Activate on RELEASE, by default. This can have some advantages and
disadvantages, depending on how you use ENDGAME.
However, if preferred for operation, this can be changed to Activate on PRESS. Note that in this
mode you will lose the ability to edit any secondary function on the y.
To swap between the 2 Foot-switch modes, unplug ENDGAME from 9 V DC power, then press
and hold the DOUBLER Foot-switch while re-powering up the pedal. The alternate Foot-switch
mode will then be active.
Notes: Changing the Foot-switch behaviour will not affect any last stored secondary function.
For example, if the TDT Timing has been adjusted in Activate on RELEASE mode and Activate on
PRESS mode is later selected, the edited Timing settings will remain, just there will be no way to
re-adjust these settings directly, unless you revert to Activate on RELEASE mode.
↻ 2024-12-10 ⋅ 17:00:00
To Previous Page
Loading...
