KMS MD35 - Function Key F10; Function Key F11; Remaining Shortcuts Alt + H

KMS MD35 manual
Version 4.16 62
3.2.10 Function key F10
Function key F10 offers the choice of working off-line or on-line. It
switches communication with the system on or off. Communication will
also be stopped when the power supply to the system is broken. If
there is no communication, a red bar will appear at the bottom of the
screen. To resume the communication with the system, function key
F10 should be pressed. A menu will appear offering a choice between
loading the file on the PC to the system and loading the file in the
system to the PC. There will still be the possibility of breaking the
communication again.
Warning:
Make sure that the battery of the vehicle supplies more than 10V. If the
battery doesn‟t exceed 10V the changes you made to the ECU will not be
saved.
Tip: On vehicles with an ignition lock switched in such a way that the power supply to the system is
cut off when the engine is started, always download the data from the PC to the system (as in the
PC the modified data will not get lost when the power supply to the system is broken). This is of
course only necessary if the data has not been saved to the system.
3.2.11 Function key F11
This function key is used to toggle between the injection diagram (blue) and the
ignition diagram (red).
3.2.12 Remaining shortcuts Alt + H
To activate this menu press Alt+H. In this menu the remaining
shortcuts are shown.