KNOX COMPANY | 800-552-5669 | TECHSUPPORT@KNOXBOX.COM | KNOXBOX.COM | OPE-KSCNFG-0292-I | PAGE 20 of 25
INSTALLING KNOXCONFIG SOFTWARE (KeySecures with FW v1.8.6 or earlier)
Devices with firmware version 1.8.6 or below must be configured using KnoxConfig. Follow these steps to
download and install the KnoxConfig Software:
1. Before you start the installation, make sure the KeySecure is not connected to the PC via USB.
2. Log into KnoxConnect at knoxconnect.net as the device administrator to download the KnoxConfig
Software.
3. From the left Selection Panel, select Admin.
4. Select the Software tab.
5. From the Software Download list, select Download the KnoxConfig Software.
6. Locate and open the downloaded KnoxConfig Software file.
7. Select the Install button to begin the installation of the KnoxConfig Software and its associated drivers.
8. Follow installation prompts to launch the software.
9. After installation is complete KnoxConfig will automatically run.
To Next Page
Loading...
Need help?
General