KNOX COMPANY | 800-552-5669 | TECHSUPPORT@KNOXBOX.COM | KNOXBOX.COM | OPE-KSCNFG-0292-I | PAGE 14 of 25
ASSIGNING PROFILES TO KNOX DEVICES
Once the network templates have been created you can assign them to your Knox devices.
1. Select the Knox Device from menu on the left. In this example KeySecure is selected however the same
navigation is used for MedVault
2. Select the Edit button for the KeySecure or MedVault you wish to apply the Network Template.
3. Scroll down to the Device Hardware Programing Section.
4. Select the Network Template you want to apply to that unit from the dropdown list.
5. If using Static IP addresses input the Static Ethernet IP or Static WiFi IP address for this device.
6. If using Enterprise Security, complete the following fields:
• Enterprise Identity
• Client Certificate: select the certificate from the dropdown list (if applicable)
• Enterprise Password (if applicable)
• Re-enter Password (if applicable)
• Enterprise Anonymous Identity (if applicable)
7. Select Save button.
To Next Page
Loading...
Need help?
General