Front towing eye
Fig. 95 Remove cap / install towing eye
Cover cap removal/fitting
›
To remove, press down on the cap in the direction of arrow
1
and remove it
in the direction of arrow
2
» fig. 95.
›
To fit it, insert the cap in arrow range
1
and then press on the opposite edge
of the cap. The cap must engage firmly.
Removing/installing the towing eye
›
To install, screw in the towing eye by hand in the direction of arrow
3
» fig. 95 until the stop» .
›
Tighten the towing eye using a wheel wrench or similar object. To do this, in-
sert the wheel wrench through the eye.
›
To removeit, unscrew the towing eye in the opposite direction to arrow
3
.
WARNING
The towing eye must always be firmly in place, otherwise the towing eye
could break whilst being towed.
Towing eye rear
Fig. 96
Rear towing eye
The rear towing eye is located below the bumper on the right.
Remote - change battery
Fig. 97
Remove cover/take out battery
›
Pop out the key bit.
›
Press off the battery cover
A
» fig. 97 with your thumb or by using a screw-
driver in the area of arrow
1
.
›
Press down on the discharged battery in the area of arrow
2
and remove it.
›
Hold any button on the key for about 5 s.
›
Insert the new battery.
›
Insert the battery cover
A
and press it down until it clicks into place.
The key has to be synchronised if the vehicle cannot be unlocked or locked
with the key after replacing the battery » page 33.
92
Do-it-yourself
To Next Page
Loading...
