Driving data (Multifunction display)
Introduction
The driving data is displayed in the multifunction display when is ignition is
switched on. After the ignition is switched on, the information that was last se-
lected before switching off the ignition is displayed.
Operation
Fig. 18
Buttons on the control lever
Operating the multifunction display » fig. 18
Press (up or down) - select data / Setting values
Press - show / confirm entry
Hold - Reset memory
Information overview
Overview of driving data (depending on the vehicle equipment).
Outside temperature - If the outside temperature drops below +4 °C, the
temperature indicator appears and a snowflake symbol (display for low tem-
perature) flashes for a few seconds, then remains displayed together with the
outside temperature.
Driving time - driving time since last clearing the memory.
Current fuel consumption
1)
- The display appears in litres/hour if the vehicle is
stationary or driving at a low speed.
A
B
Average fuel consumption - is calculated continuously since the last clearing
of the memory. After erasing the memory, no data will appear for the first 300
m driven.
Range - Drive distance in km which can be covered with the existing tank ca-
pacity and with the same driving style. If you drive more efficiently, this value
can increase.
Distance driven - distance driven since the memory was last cleared.
Average speed - value constantly recalculated, for distance since last clearing
the memory. After erasing the memory, no data will appear for the first 300 m
driven.
Current Speed - digital speedometer.
Coolant temperature - If the coolant temperature is in the range 70-120 °C,
the engine operating temperature has been reached. If the temperature is be-
low 70 ° C, high engine speeds and straining the engine should be avoided. If
the temperature is over 120 ° C, the warning light lights up the instrument
cluster
» page 24.
Warning when speeding - It is possible to set a speed limit.
Warning if the set speed is exceeded
The system offers the possibility to set a speed limit beyond which an acoustic
warning signal will sound and the symbol appears in the display at the same
time
with the set limit.
Adjust the speed limit while the vehicle is stationary
›
Select and confirm the menu item (warning when speed limit is exceeded).
›
Set the desired speed limit.
›
Confirm the set value, or wait several seconds; your settings will be saved
automatically.
Adjusting the speed limit while the vehicle is moving
›
Select and confirm the menu item (warning when speed limit is exceeded).
›
Drive at the desired speed.
›
Confirm the current speed as the speed limit.
The set speed limit can be manually adjusted later if needed.
1)
Only valid for some countries.
29
Information system
To Next Page
Loading...
Need help?
General
