Attaching the wiper blade
›
Slide the windscreen wiper blade in the opposite direction to arrow
2
until
it locks into place. Check that the wiper blade is correctly attached.
›
Fold the wiper arm back to the windscreen.
Fuses and light bulbs
Fuses
Introduction
Fig. 101
Blown fuse
Individual electrical circuits are protected by fuses. A blown fuse is recognisa-
ble from the melted-through metal strip » fig. 101.
WARNING
Always read and observe the warnings before completing any work in the
engine compartment » page 75, Engine compartment.
CAUTION
■
Replace the faulty fuse with a new one of the same amperage.
■
If a newly inserted fuse again blows after a short time, then seek assistance
from a specialist garage.
■
“Do not repair” the fuses and do not replace them with stronger fuses -
There is a risk of fire and damage to another electrical system.
Notice
■
We recommend always carrying replacement fuses in the vehicle.
■
There can be several power consuming devices for one fuse. Multiple fuses
may exist for a single power consuming device.
94
Do-it-yourself
To Next Page
Loading...
