Setting Up the Printer
October 2020 2-15
15. Load the ribbon. See “Loading the Ribbon” on page 2-16.
16. Close the front of the printer.
Once the ribbon is loaded, the light on the front of the printer
blinks green and the printer automatically loads the paper. If the
light blinks red, there is an error with media loading.
Six blank sheets of paper are advanced. This portion of the roll
may have fingerprints from handling. This does not decrease the
print capacity of the roll.
17. Insert the trim tray. See “Installing the Trim Tray” on page 2-5.
Note: If the trim tray is not inserted properly, a paper jam can
occur.
18. Wait for the blank sheets to exit the printer.
19. Install the exit tray (if present).
To Next Page
Loading...
