Setting Up the Printer
October 2020 2-21
Starting the Software Operator Control Panel
Launch the software operator control panel to view the printer
status and change the printer settings. Do not use the Software
Operator Control Panel (SOCP) when printing with the driver.
Close the SOCP before you print. If the SOCP is left open when
printing, the SOCP will close and the printer may reboot. If there
are jobs in the print queue, printing will resume after the reboot.
1. Connect the printer to a PC with a USB cable.
2. From the PC, double-click “SOCPstartup.exe”.
3. Wait for “Ready 6x8” or “Ready 5x7” to appear in the
software operator control panel.
Note: If you have two printers connected to your computer, two
separate software operator control panels appear on your
screen.
4. For more information on using the software operator control
panel in Setup mode, see “Printer Settings” on page 4-3.
To Next Page
Loading...
