Maintaining the Printer
October 2020 3-3
7. Remove a new alcohol pad from its packaging. Move the pad
along the entire length of the thermal print head, in one
direction only. When you clean the thermal head:
• Apply firm, even pressure.
• Make three passes along the thermal print head.
• Use a clean part of the pad for each pass.
8. Use a new alcohol pad to wipe the peel roller. Rotate the roller
to clean the entire roller surface.
9. Allow the alcohol to dry completely (about five minutes)
before you resume printing.
10. Move the power switch to the On (
| ) position.
CAUTION: HOT!
Thermal Print Head
To Next Page
Loading...
