3-8 October 2020
Maintaining the Printer
The thermal print head becomes extremely hot during
normal operation. Wait approximately five minutes after you
open the front of the printer before cleaning it. Fingerprints
can damage the thermal head. Never touch it with your bare
hands or fingers.
5. Carefully lower the door until it is fully open.
6. Remove the ribbon and paper.
7. Remove a new alcohol pad from its packaging. Wipe the
rubber section of the cleaning roller with the pad.
8. Rotate the roller to clean the entire surface.
9. Allow the alcohol to dry completely (about five minutes)
before you resume printing.
10. Move the power switch to the On (
| ) position.
To Next Page
Loading...
