4-4 October 2020
Operating the Printer
Do not use the Software Operator Control Panel (SOCP) when
printing with the driver. Close the SOCP before you print. If the
SOCP is left open when printing, the SOCP will close and the
printer may reboot. If there are jobs in the print queue, printing
will resume after the reboot.
STATUS PRINT ---- Prints a sheet with the printer serial number, counts,
errors, and firmware information.
Clear Slitter ---- This feature turns on the slitter drive mechanism for
a few seconds. Use this if there is a jam in the slitter.
Combo Wait Set Wait Combo The amount of time the Printer waits for the next
print.
Display - Level 1 Display - Level 2 Description
To Next Page
Loading...
