Troubleshooting
72 www.kodak.com/go/aiosupport
Status lights
The status lights indicate the condition of the printer. There are two status lights on
the printer: one on the on/off button that indicates power, the other indicates Wi-Fi
status.
Power light
Wi-Fi connectivity LED
Power light What it means
Off
• The printer is turned off.
– Press the on/off button to turn on power.
• The printer does not have power.
– Make sure that the power cord is plugged into the
back of the printer and into an electrical outlet, and
that the electrical outlet has power.
Blinking
• The printer is busy.
– Wait for the printer to finish the task.
On
• The printer is ready.
Wi-Fi connectivity LED What it means
Off The Wi-Fi radio is either turned off or is turned on but not
connected to a wireless network.
Blinks continuously The Wi-Fi radio is turned on, and the printer is searching for
available wireless networks within range.
Blinks intermittently The Wi-Fi radio is turned on and the printer cannot find any
available wireless networks within range, or the Wi-Fi radio
connection has been interrupted, or is too weak to send
signals to and from the printer.
To find and connect to an available wireless network within
range, press OK, turn the Wi-Fi radio off, and run the Wi-Fi
Setup Wizard (see Connecting to a wireless network,
page 6).
On The Wi-Fi radio is turned on, and there is a working
connection between the printer and a wireless network.
To Next Page
Loading...
Need help?
General
