Kodak CAROUSEL 4400 User Manual

QUICK START-UP
Only brief operating instructions
are given on this page. Read on for
important details.
ROOMLIGHT OUTLET
REMOTE-CONTROL CORD
1
Unwind the power cord from the cord
retainer on the underside of the projec-
tor. (The cord will
not be wrapped
around the retainer when shipped.) Re-
move the REMOTE·CONTROL CORD from
the cord comp art m ent at the front of
the projector, n ext to the len s. Plug the
remote-co ntrol cord into the rear of
th e projector. See pages 4 and 6 for
which power outlet to use with
your model projector. If you plug
your projector into the wrong elec-
trical source, the projector can be
damaged.
FORWARD BUTTON
A
4
Briefly push the FORWARD BUTTON on
the projector or the FOR (forward)
button on the remot e control to pro-
ject the first slide onto the screen. See
page
8.
TRAY INDEX BAR
GA" 'N'" ~
Place a loaded slide tray on the projec-
tor with the TRAY INDEX BAR opposite
the GATE INDEX. See page 7.
5
Rotat e the FOCUS KNOB until the pro-
jected image is critically sharp. With
auto-focus projectors, only
this first
slide requires focusing
if all slides are
in the same type of mount .
For auto-focus operation with inter-
mixed types
of slide mounts, see page 8
under "Focus."
POWER SWITCH
3
Slide the POWER SWITCH to LAMP , LO,
or HI. See page 8.
SELECT BAR
6
Briefly push the forward button on the
proj ector or on the remote control to
change slides. For immediate random
projection
of any slide in the tray, pr ess
and hold down the SELECT BAR, rotate
the tray to the desired slide number ,
and then release the sel ect bar . The
select bar also ca n be used when the
proj ector is turned off or unplugged.
See page
8.
To show your slides on the built-in
viewer/Slide-Scan screen, see
page 6.
Projection-Lamp Tips
• Rough treatment of the proj ector
may damage the projection lamp.
•
Setting the power switch at LO (ex-
cept for model 4200) considerably
lengthens lamp lif e.
• Projector operation on line voltages
above
125 volts greatly reduces the
lamp lif e.
• Turn projector off when finished.
Turning to FAN can shorten lamp
life.
•
Unplug the power cord before
c
hangin g the lamp.
• Allow for
unrestricted flow of air to
the exhaust vent at the rear of the
projector .
5

Kodak CAROUSEL 4400 Specifications

General

Brand	Kodak
Model	CAROUSEL 4400
Category	Projector
Language	English