Kodak Carousel 650H User Manual

THERMAL FUSES
Your projector is equipped with thermal fuses to prevent
overheating and possible damage to the projector in case
of exhaust·fan or motor f
ai lure. If overheating causes the
fuses to open, the projector will not operate. The projector
wil l require factor y or repai r·station attention to make it
run again. Refer to the service faci li ties listed at the back
of this manual.
EMERGENCY SLIDE-TRAY REMOVAL
If the slide·changing mechanism should beco me in opera·
tive because of a defective slide (see page 7) , a foreign
object, etc, turn the co in-slotted TR AY ·REMO VA L SCR EW in
ei ther direction, as fa r as it will go, to retract the tr ay loc k.
While holding the screw in this position, lift off the tray.
When you remove the tray in this manner,
turn t he tray up·
side down and realign the ind ex notch an d in dex hole as
described on page 7; then set the tray to one side. Remove
the defective slide from the projector
by pushing down·
ward on the se le ct bar, or if necessar y, pull the slide from
PROJECTION TIPS _~~~~~~~~_th_e_~_te_b_y_h_an_d_.R_e_p_lac_e_th_e_t_ra_y_On_t_he_p_rO_je_c_to_r.~_
LONG-RUN APPLICATIONS
Allow for unrestricted flow of air through the projector
openings.
If the projec tor is used in a window display or in
a cabinet, provide
an adequate outlet for the warm air ex·
pelled from the rear grille vent. The air ci r cu lating through
the projector should be as dust·free as possible.
EDITING SLIDES
If you want to edit your slides, you may project them
singly, as described on page
10 . Or place a tray of slides
on the projector. Remove the lock ring from the tray . To
edit a slide after viewing, firmly press and hold down the
select bar, and remove the slide from the tray . You can
then reorient the slide or replace it with another sl id e. (The
optional
KODAK CAROUSEL Stack Loader, described on page
14 , provides a convenient method for editing your slides.)
PROJECTING 110 SLIDES
When you have lID -size slide film pro ce ssed , it will be
returned to you in 2 x 2-inch slide mounts.
You may request mounting of size 110 film in 30 x
30 mm mounts from the laboratory that processes your
film. This service is available at no extra charge from Kodak
Color Processing Laboratori es in the U.S. ana Canada , as
well as other processing laboratories, if you request it at
the time of processing.
A slide in a
30 x 30 mm mount cannot be used in your
projector unless
it is placed in a 2 x 2·inch adapter (shown
on page 14). To obtain large scr een images when you
project
110 slides, use a short-focal-Iength lens, such as
a 2
1
/
2
-inch or 3·inch KODAK Projection Lens.
13

Kodak Carousel 650H Specifications

General

Brand	Kodak
Model	Carousel 650H
Category	Projector
Language	English