TRAY
8
PLACING
SLIDE
TRAY
ONTO
PROJECTOR
Place the loaded slide tray
on
the projector
so
that the hole
in the center of the tray fits over the center post
on
the
top
of the projector; then turn the tray slowly in a
clockwise
direction until the TRAY
INDEX
BAR is opposite the GATE
INDEX
on
the projector. The tray will drop down into operating
position
on
the projector. If the tray does not drop easily
into place, check the alignment of the index hole and the
index notch
as
described under
"Loading
Slide Tray"
on
page
7.
Note: The tray will drop
farther
down
on
the
projector
during
the
first
change cycle.
POWER
SWITCH
PROJECTING
SLIDES
Turn
on
the projection lamp
by
sliding the POWER SWITCH to
LAM
P.
Briefly press the FORWARD BUTTON
on
the projector
or
the
FOR
(forward) button
on
the remote control to put
the
first
slide into viewing position.
ELEVATION
To
center the projected image
on
the screen vertically,
elevate the
front
of the proj,:ctor
by
turning
the ELEVATING
WHEEL.
FORWARD
AND
REVERSE
BUTTON
S
FORWARD and REVERSE
BUTTONS,
located
on
the side of the
projector, control the direction in which the tray rotates.
ELEVATING
WHEEL
To Next Page
Loading...
Need help?
General