10
RANDOM
SELECTION
OF
SLIDES
IN
TRAYS
To project a particular slide in a tr
ay
:
1. Press the SELECT BAR
firmly
and
hold
it
down.
2.
Rotate the tray until the number of the slide you want
to
project
is
opposite the gate index
on
the projector.
3. Release the select bar; the desired slide will
be
pro·
jected immediately.
REMOVING
SLIDE
TRAY
1. With the projector turned on, press the SELECT BAR
fi rmly and hold
it
down.
2. Rotate the
tray
until the tray index bar is opposite the
gate index.
3.
Release the select bar and then
lift
off the tray.
SHOWING
SINGLE
SLIDES
1. With the projector turned
on
, insert a slide (correctly
oriented) into the projector gate. Push the slide down
into the gate
as
far
as
it
will go.
2. After viewing the slide, press the SELECT BAR
to
eject the
slide from the gate. Y
ou
c
an
now insert another slide
into the gate. (Slides up to
lis
inch
thick
can
be
pro-
jected
by
this method.)
AFTER
THE
SHOW
l.
Remove the tray; then slide the power switch
to
OFF.
2. Lower the
front
of the projector
by
turning
the elevating
wheel. Retract the rear leveling foot.
3. Retract the lens (except zoom lens)
by
turning
the focus
knob counterclockwise.
4.
Unplug the power and remote-control cords. Fold the
power cord
in
about 4·inch lengths and place it
in
the
cord compartment. Fold t
he
remote-control cord
by
placing the ends together a
nd
folding it
in
about 4-inch
lengths. Place
it
in
the cord compartment.
To Next Page
Loading...
Need help?
General
