Kodak EKTAGRAPHIC AF-2 - The Controls and Their Functions; On-Projector Controls; Advanced Operation Modes; Maintenance Operations

ELEVATING WHEEL. To raise or lower the image on the screen, turn the elevating
wheel on the front of the projector.
LEVELING-FOOT WHEEL. To raise or lower the left side of the image on the screen,
turn the leveling - foot wheel.
REMOTE CONTROL (Timer set at M ). To project the slide with the next higher identifi-
cation number, momentarily depress the forward button; to rotate the tray one slide
space in the reverse (clockwise) direction, depress and release the reverse button.
(Press the reverse button firmly ; if this button is pressed too lightly , the tray may rotate
in a forward direction .) To focus the image on the screen, use the focus lever .
These functions can also be accomplished by operating the forward button , the
reverse button, and the focus knob on the projector body .
RANDOM PROJECTION (Timer set at M ). To project a slide out of sequence:
1.
Firmly depress the select button and hold it down.
2. Rotate the sl i de tray until the slide you want to project is opposite the gate
index on the projector .
3. Release the select
button . The selected slide will be immediately prOjected.
AUTOMATIC TIMER. For automatic advance of slides at intervals of 5, 8, or 15 seconds,
set the timer at "5", " 8", or "15 " respectively .
SLIDE-TRAY REMOVAL. If the zero position on the tray is opposite the gate index,
simply lift off the tray . Otherwise :
1.
With the projector turned on, depress the select button firmly and hold it down .
2. Rotate the slide tray- in either direction- until the zero position is opposite the
gate index .
3. Release the select button and then lift off the tray .
EMERGENCY SLIDE-TRAY REMOVAL. If for any reason it becomes necessary to remove
the tray without returning it to the zero position, use this procedure :
1. Turn the coin-slotted tray removal screw in either direction as far as it will go .
2. Hold the screw in this position and lift off the tray.
3. Turn the tray upside down and rotate the bottom plate until it locks.
PROJECTION LAMP REPLACEMENT.
If the lamp burns out during a showing :
1. Allow the fan to run to cool the lamp and lamp compartment.
2. Remove the slide tray .
3.
Move the switch to OFF.
4.
Disconnect the power cord.
5. Turn the projector upside down.
6. Open the lamp door by turning the coin-slotted screw counterclockwise.
7. Release the lamp ejector lever from the notch in which it is secured. Lift the
lever to eject the lamp . Withdraw the lamp.
8. Place a new lamp ( ANSI Code ELH ) in the socket with the two pins on its base
fitting the two slots in the socket. ( Code ENH lamp can be used for extended lamp
life with less output; ENG lamp for more brightness, but shorter life .)
9. Return the ejector lever to its original position and make sure it is latched. The
lever will locate the lamp correctly for operation .
10.
Close and fasten the lamp door.
For more detailed information, refer to the instruction manual.
Kodok and Ektagraph ic are trademarks.
Motion Picture and Education Markets Division
EASTMAN KODAK COMPANY· ROCHESTER, N. Y. 14650
Pub. Pt. No . 634465
280·12- 71 -AE-Minor Revision