Safety
nformation
•
Read
and
follow
these
instructions
before using
KODAK
Products.
•
Always
follow
basic safety procedures.
• Follow all
warnings
and
instructions
marked on
the
equipment.
WARNING STATEME
TS
• Do
not
expose
this
product
to
liquid, moisture,
or
extreme
temperatures.
KODAK
AC
Adapters
are intended
for
indoor
use only. The use
of
controls,
adjustments,
or
procedures
other
than those specified herein
may
result in
exposure
to
shock
and/or
electrical
or
mechanical hazards.
• Keep ink cartridges
out
of
reach
of
children. Ink
may
be
harmful
if
swallowed.
• Do
not
place
your
AII-in-One
Printer on
an
unstable cart, stand, bracket,
or
table. Injury
to
persons and damage
to
the
equipment
may
occur.
• The use
of
an
accessory
attachment
that
is
not
recommended
by Kodak, such
as
an AC adapter,
may
cause fire, electric shock,
or
injury.
• Pushing objects
through
the
equipment
openings can result in
an
electric shock
or
risk
of
fi
reo
CAUTIONARY STATEMENTS
•
Adjust
only
those
controls
covered in
the
operating
instructions.
• Do
not
disassemble
this
product;
there are no user-serviceable parts inside.
Refer servicing
to
qualified
service personnel.
• The AC
adapter
power
supply
is equipped
with
3-wire
grounding
type
plugs. If
you
cannot
insert
the
plug
into
the
power
outlet,
contact
an electrician
to
check
or
replace
the
power
outlet.
• Do
not
plug
the
AC
adapter
into
a household extension cord.
• If
the
power
cord
or
plug is frayed
or
damaged,
the
equipment
gets wet,
or
the
equipment
does
not
operate
normally
when
the
operating
instructions
are
followed,
unplug
your
All-in-One
Printer
from
the
power
outlet
and
contact
Kodak qualified service personnel
for
further
instructions.
• For added
protection
from
damage
during
a
lightning
storm,
or
any
time
when
your
AII-in-One
Printer and its associated AC
adapter
will
be
left
unused
for
long periods
of
time,
unplug
the
AC
adapter
from
the
power
outlet
and any
attached fax line
from
the
printer.
•
To
prevent
your
AII-in-One
Printer
from
overheating, do
not
place
it
near a heat
register,
or
install
it
in a
cabinet
without
proper ventilation.
• Do
not
use
your
All-in-One
Printer near
water
or
spill liquid on it.
•
Unplug
the
equipment
from
the
wall
outlet
before cleaning.
•
Dropping
your
AII-in-One
Printer
may
damage
the
housing and result in
extensive damage
that
will
require repair by a qualified
technician
to
restore
normal
operation.
• Excessive
dust
levels
may
damage internal parts.
For
more
information,
go
to
vww.koda
.com/go/MSDS
14
www.kodak.com/go/aio5upport
To Next Page
Loading...
