Safety
and
Warranty
Information
Safety Information
• Always follow all warnings and instructions marked on the product.
• Use only the power source indicated
on
the product regulatory label.
• Use only the power cord
that
comes
with
the product. Using another power cord may
cause fires and
or
shock. Do not use the included power cord
with
any other equipment.
• If you do not use this product for a long period of time, unplug
it
from the electrical
outlet.
• Always turn this product off by using the
On/Off
button.
Wait
until the
On/Off
button
stops flashing before removing the power plug from the outlet.
• Do not allow the power cord
to
become damaged or frayed.
• If you need to use
an
extension cord
with
this product, make sure
that
the ampere rating
of the product does not exceed the ampere rating of the extension cord.
• Place the product
on
a flat, stable surface that extends beyond the product's base
in
all
directions. This product will not operate properly if tilted or at
an
angle.
•
When
storing or transporting this product, do not
tilt
or stand
it
on its side. Never turn
this product upside down (ink can leak out of the product).
• Avoid placing this product in
an
environment
that
is
subject to rapid changes
in
temperature or humidity, mechanical shocks, vibration, or dust. Do not place near
radiators, heating vents, or
in
direct sunlight.
•
Leave
enough room around this product for sufficient ventilation.
• Do not block this product's covers or openings, or insert any objects through slots.
• Do not use aerosol products inside or around this product.
• Do not spill any liquid
on
this product.
• Do not
attempt
to repair or service this product.
• If the power cord or plug
is
damaged,
if
any liquid has been spilled onto the product,
if
the product has been dropped or the case damaged,
if
the product does not operate
normally or exhibits a major change in performance level, unplug this product and
contact Kodak at
www.kodakcom/go/contact.
LCD
Screen Safety
• Use only a dry, soft cloth to clean the
LCD
screen. Do not use any liquid or chemical
cleaners.
• If the
LCD
screen
is
damaged, contact Kodak immediately. If any of the solution from
the display gets on your hands, wash then thoroughly
with
soap and water. If the liquid
crystal solution gets into your eyes, flush your eyes immediately
with
water. If any
discomfort or change in vision persists after washing, seek medical attention
immediately.
Ink Cartridge Safety
• Keep all ink cartridges out of the reach of children.
• If ink gets
on
your skin, wash
with
soap and water. If ink gets into your eyes, flush
immediately with water. If any discomfort or change in vision persists after washing,
seek medical attention immediately.
•
For
MSDS information
on
inks, go to www.kodak.com/go/MSDS.
14
www.kodak.com/go/aio5upport
To Next Page
Loading...
Need help?
General
