Kodak HERO 9.1 - Page 100

Faxing
94 www.kodak.com/go/aiosupport
Connecting to an
Internet or cable
telephone service
(Voice-Over-Internet
Protocol or VOIP)
If you have an Internet or cable (Voice-Over-Internet Protocol or VOIP) telephone
service, you should already have a cable modem/router connected to the cable
outlet with a coaxial cable. You will also need an Analog Telephone Adapter (ATA) to
connect your printer for faxing.
NOTE: Sometimes the cable modem/router has a built-in ATA. Contact your cable
telephone service provider for more information.
1. Connect an RJ-45 (also called CAT 5) cable from the cable modem/router to the
WAN port on the Analog Telephone Adapter (ATA).
2. Connect one end of the phone cord that came with the printer (RJ-11 telephone
cord) to one of the phone input ports on the ATA and the other end to the LINE
IN port on the back of your printer.
Coaxial
RJ-45 cable
RJ-11
Cable outlet
Cable
Analog Telephone
modem/router
Adapter (ATA)
(CAT 5 cable)
telephone cord
cable