2 A-61655 November 2009
Starting Smart Touch Smart Touch runs from the system tray. After the software drivers and
scanner are properly installed, Smart Touch is started and a Scanner
icon will be displayed on the system tray.
Launching from the scanner:
• Press the Scroll button to go through the function numbers and
select the desired function, then press the Start button. The task
associated with the selected function number will be run.
NOTE: The Scroll and Start buttons are located on the front of the
scanner.
Launching from the Smart Touch function listing:
• Click the Scanner icon to display the function listing and select the
function number you want to run.
Ready
Not Ready
Kodak i1200/i1300 Series Scanners
To Next Page
Loading...
