Kodak Pixpro 4KVR360 - Mounting; Removing Lens Ring and Lens Cover

11
Mounting / Removing Lens Ring and Lens Cover
Removing lens cover:
Turn the lens cover according to the illustrated direction until it separates from
the 4KVR360.
Mounting lens cover
Turn and irmly tighten the lens cover according to the illustrated direction.
The lens cover protects the lens from being damaged (dustproof, shockproof and splash proof). Using the lens cover when taking a photo/shooting a video
will not inluence the image/video quality.
Before mounting the lens cover, make sure the lens surface is clean and dry. Always use a clean, lint-free dry cloth to clean the lens before shooting or
recording so it will not aect the photo or video quality.
When the 4KVR360 is exposed to extreme temperature dierences condensation may form inside of the lens cover. If this happens, remove the lens cover,
clean it with a soft, dry, lint-free cloth, and then reinstall the lens cover.
If the 4KVR360 will not be used for a period of time, always put the protective cover on it (as shown in the igure).
The processes of mounting/removing lens ring and lens cover are the same, with lens cover as an example as below: