Kodak PIXPRO Astro Zoom AZ401 User Manual

88 8988
Connecting to your Printer
1. Make sure the printer is turned on.
2. Connect one end of the micro USB
cable to the USB port on your camera.
3. Connect the other end of the micro
USB cable to the USB port on the
printer.
If the camera is not connected to a
PICTBRIDGE™ compatible printer, the
following error message will appear on
the LCD.
The error message above will
also appear if the USB mode is
set incorrectly, in which case you
should disconnect the micro USB
cable, check the USB mode settings,
ensure that the printer is turned on,
then try connecting the micro USB
cable again.

Kodak PIXPRO Astro Zoom AZ401 Specifications

General

Sensor Type	CCD
Sensor Size	1/2.3 inch
Effective Pixels	16.15 MP
Optical Zoom	40x
Image Stabilization	Optical
LCD Screen Size	3.0 inch
LCD Resolution	460, 000 dots
Image Resolution	4608 x 3456
Digital Zoom	4x
Storage Media	SD/SDHC Card
Type	Bridge Camera
Focal Length	4.3-172 mm
Aperture Range	f/3.0-6.8
ISO Sensitivity	ISO 80-3200
Shutter Speed	1/2000 - 8 sec
Video Resolution	1280 x 720 (HD)
Battery Type	4 x AA Batteries