A-61676 June 2010 4-11
5. Back sensor roller: Push back the wire springs that hold the back
sensor roller in place and lift the roller up and out of the holder.
6. Take the new back sensor roller (shorter roller), gently lift the right
spring and insert the back sensor roller in place; then lift the left
spring and insert the other side of the roller in place. The white gear
should be on the right.
7. Verify that the back roller sensor is securely in place.
8. Gently close the ADF door and turn on the scanner.
Back sensor
roller
Wire spring
To Next Page
Loading...
