Koden MDC-2240 - Page 10

Table of Contents MDC-2200/2500 Series
0093125002-04 iv
(26) Full screen display
..........................................................................................4-17
(27) Off center position
...........................................................................................4-17
4.4 NAV menu
..................................................................................................................... 4-18
(1) Select stabilization base (SEA/GND)
................................................................4-18
(2) Set up tide bearing
............................................................................................4-18
(3) Set up tide speed
..............................................................................................4-18
(4) Set up vector display time
.................................................................................4-18
(5) Set up vector display mode
...............................................................................4-19
(6) Use navline
.......................................................................................................4-19
(7) Select block no. of navline
................................................................................4-19
(8) Delete navline by designating block no.
............................................................4-19
(9) Set up detection function
..................................................................................4-19
(10) Input/edit navline data
.....................................................................................4-19
4.5 ALARM menu
................................................................................................................ 4-20
(1) Use guard zone
.................................................................................................4-20
(2) Setup CPA
.........................................................................................................4-22
(3) Setup TCPA
.......................................................................................................4-22
(4) Setup ATA buzzer sound
...................................................................................4-22
(5) Setup AIS buzzer sound
....................................................................................4-22
(6) Use Alarm 1
.......................................................................................................4-22
(7) Setup Alarm 1 detection mode
..........................................................................4-24
(8) Setup Alarm 1 detection level
...........................................................................4-24
(9) Setup Alarm 1 area setting method
...................................................................4-24
(10) Use Alarm 2
.....................................................................................................4-24
(11) Select Alarm 2 block number
...........................................................................4-24
(12) Delete registered data by designating block number
......................................4-25
(13) Select Alarm 2 detection method
....................................................................4-25
(14) Setup Alarm 2 detection level
.........................................................................4-25
(15) Input/edit Alarm 2 data
....................................................................................4-25
Delete alarm sound
................................................................................................4-26
4.6 ATA/EPA menu
.............................................................................................................. 4-27
(1) Select ATA function or EPA function
..................................................................4-27
(2) Manual target acquisition
..................................................................................4-27
(3) Select acquired target and delete it
..................................................................4-27
(4) Delete all acquired targets
................................................................................4-28
(5) Setting method for acquiring number manually
................................................4-28
(6) Auto acquisition
.................................................................................................4-28
(7) Set up target ID display
.....................................................................................4-28
(8) ID size
...............................................................................................................4-28