MDC-2200/2500 Series Chapter 4 Menu operations
0093125002-05 4-31
(3) Select target
Switch Active <=> Sleep in AIS information display.
This item is to select target when displaying detailed AIS information in data display area at lower
screen.
Select target then press [ENT] key, then data is switched over.
The same operation can be performed on the screen by moving cursor to the target to be displayed
then press [ENT] key.
・Change from sleep display to active display: Point cursor on target to change then press [ENT] key.
・Change from active display to sleep display : Point cursor on target to change then press [ENT] key
while pressing [OFF] key.
(4) Setup detection area (Display area setup)
Setup area to display AIS information.
Setup by range of 1.0NM to 64.0NM area from own ship.
・ Extension of detection area setting in crowded place may exceed 200 of maximum displayable
number. Pay attention, if such case happened, “Overflow” message is displayed and alarm is
sounded and display of further other ships becomes unavailable.
(5) Setup lost target display
Setup lost alarm display for lost target.
ON: Display lost alarm and sound alarm.
OFF: Lost alarm is not displayed.
(6) Setup sleep ship display
Setup sleep symbol display.
OFF: Sleep ship is not displayed.
A : Display Class A sleep ship.
B : Display Class B sleep ship.
BOTH: Display both Class A and Class B sleep ship.
(7) Setup class B target display
Setup class B target symbol display.
ON: Display class B target symbol.
OFF: Class B target symbol is not displayed.
(8) Setup ATON target display
Setup ATON target symbol display.
ON: Display ATON target symbol.
OFF: ATON target symbol is not displayed.
To Next Page
Loading...
