MDC-2200/2500 Series Chapter 4 Menu operations
0093125002-05 4-59
(3) External load
This command is for maintenance by dedicated tool in PC.
This is to load the preset values saved in PC by (4) External save into radar.
This brings the values back to the setting last time it was saved.
(4) External save
This command is for maintenance by dedicated tool in PC.
This is to save the setting values into PC.
The saved setting can be loaded by (3) External load.
(5) System program load
This command is for maintenance by dedicated tool in PC.
This is to update the software program on the main unit.
(6) ATA program load
This command is for maintenance by dedicated tool in PC.
This is to update the ATA software program.
(7) AIS program load
Not available.
(8) Mark load
This command is for maintenance by dedicated tool in PC.
This is to load the data related to mark (NAVLINE, ALARM2, MARK, COAST LINE) saved in PC by (9)
Mark save.
(9) Mark save
This command is for maintenance by dedicated tool in PC.
This is to save the data related to mark (NAVLINE, ALARM2, MARK, COAST LINE) in PC.
Loading of the saved data can be done by (8) Mark load.
(10) Past load
This command is for maintenance by dedicated tool in PC.
This is to load the data related to trail (OWN, ATA, AIS) saved in PC by (11) Past save.
(11) Past save
This command is for maintenance by dedicated tool in PC.
This is to save the data related to trail (OWN, ATA, AIS trail) in PC.
The saved data can be loaded by (10) Past load.
To Next Page
Loading...
