10.17
Section 10
Reassembly
10
Figure 10-59. Air Cleaner Base Upper Mounting
Tab Details.
Figure 10-60. Installing Air Cleaner Base.
b. Models with one screw and one mounting
stud only: Apply hand pressure to keep the
parts from shifting, then carefully remove the
alignment pin and install DRY the long M6
thread forming screw – DO NOT OIL. See
Figure 10-61. Check to make sure all
gaskets are still in proper position.
Figure 10-61. Installing Mounting Screw. (Models
with one stud and one screw).
Tab on Top of Closure Plate
Figure 10-62. Torquing Air Cleaner Fasteners.
10. Attach the breather hose to the valve cover and
air cleaner base.
Install and Adjust Governor Lever
1. Install the governor lever* onto the governor shaft
with the lever section up. Connect the throttle
linkage using the black linkage bushing. See
Figure 10-63.
*NOTE: It is recommended that a new governor lever
be installed whenever removal is performed.
c. Torque the nut(s) to 5.5 N·m (48 in. lb.).
Torque the screw to 8.0 N·m (70 in. lb.) into a
new hole, or 5.5 N·m (48 in. lb.) into a used
hole, do not over tighten. See Figure 10-62.
The M6 screw for the upper tab will be
installed when the blower housing is mounted.
Figure 10-63. Governor Lever Installed on Shaft.
Not For Resale
www.SmallEngineDiscount.com
To Next Page
Loading...
