5.15
Section 5
Fuel System and Governor
5
Governor Sensitivity Adjustment
Governor sensitivity is adjusted by repositioning the
governor spring in the holes in the governor lever. If
speed surging occurs with a change in load, the
governor is set too sensitive. If a big drop in speed
occurs when a normal load is applied, the governor
should be set for greater sensitivity.
Governor
Lever
Hole No.
High Speed
RPM
3201-3400
2
Throttle
Lever
Hole No.
X
Governor Lever
Green
Spring
X
The desired high speed setting (RPM) will determine
the governor spring position in the governor lever and
the throttle lever, as well as the spring used. See
Figure 5-23.
Figure 5-23. Governor Spring Location Chart.
Throttle
Lever
White
Spring
Governed
Idle RPM
1601-1800
2
2
2
3201-3400
Not For Resale
www.SmallEngineDiscount.com
To Next Page
Loading...
