9.13
Section 9
Inspection and Reconditioning
9
3. Make sure governor gear assembly rotates freely.
4. Check that timing marks are still aligned.
5. Install a new closure plate gasket and install the
closure plate. Refer to ‘‘Reassembly’’ Section 10
for proper torque sequence and specification.
6. Complete engine reassembly following
“Reassembly” procedures.
7. When engine reassembly is completed, reset
initial governor adjustment according to
procedure in ‘‘Fuel System and Governor’’
Section 5.
Not For Resale
www.SmallEngineDiscount.com
To Next Page
Loading...
