2.1
Section 2
Tools & Aids
2
Section 2
Tools & Aids
Certain quality tools are designed to help you perform specific disassembly, repair, and reassembly procedures.
By using tools designed for the job, you can properly service engines easier, faster, and safer! In addition, you’ll
increase your service capabilities and customer satisfaction by decreasing engine downtime.
Here is the list of tools and their source.
Separate Tool Suppliers:
Kohler Tools
Contact your source
of supply.
SE Tools
415 Howard St.
Lapeer, MI 48446
Phone 810-664-2981
Toll Free 800-664-2981
Fax 810-664-8181
Design Technology Inc.
768 Burr Oak Drive
Westmont, IL 60559
Phone 630-920-1300
Tools
Description Source/Part No.
Camsha Endplay Plate
For checking camsha endplay.
SE Tools KLR-82405
Camsha Seal Protector (Aegis)
To protect seal during camsha installation.
SE Tools KLR-82417
Cylinder Leakdown Tester
For checking combustion retention and if cylinder, piston, rings, or valves are worn.
Kohler 25 761 05-S
Electronic Fuel Injection (EFI) Diagnostic Soware
Use with Laptop or Desktop PC.
Kohler 25 761 23-S
EFI Service Kit
For troubleshooting and seing up an EFI engine.
Kohler 24 761 01-S
Individual Components Available
Pressure Tester
Noid Light
90° Adapter
Oetiker Clamp Pliers
Code Plug, Red Wire
Code Plug, Blue Wire
Design Technology Inc.
DTI-019
DTI-021
DTI-023
DTI-025
DTI-027
DTI-029
Flywheel Holding Tool (CS Series) SE Tools KLR-82407
Flywheel Puller
To remove flywheel from engine.
SE Tools KLR-82408
Flywheel Strap Wrench
To hold flywheel during removal.
SE Tools KLR-82409
To Next Page
Loading...
