Kohler COURAGE SV710-740 - Remove Throttle Controls

8.3
Section 8
Disassembly
8
Figure 8-7. Removing Pulse Pump.
Remove Blower Housing and Outer
%DIÀHV
1. Remove the six hex flange screws securing the
blower housing. See Figure 8-8.
2. Remove the blower housing from the engine. See
Figure 8-9.
3. Remove the M6 mounting screw on the boom
of each outer baffle into the cylinder, and the
M5 screws going into the backing plate and the
cylinder head flange. One screw may also secure
the li strap on one side.
)LJXUH2XWHU%DIÀHV0RXQWLQJ6FUHZV
Remove Throttle Controls
1. Remove the four hex flange screws securing the
throle control bracket to the cylinder heads. See
Figure 8-11.
5HPRYH0XIÀHU
1. Remove the exhaust system and aaching
hardware from the engine.
Remove Fuel Pump (Equipped Models)
WARNING: Explosive Fuel!
ȱ¢ȱȱȱȱȱȱȱȱ¢ǯȱ
ȱȱ¡¢ȱĚȱȱȱȱȱ¡ȱ
ȱǯȱȱǰȱȱĚȱȱȱȱȱ
ȱ¢ȱȱȱǯ
1. Disconnect the pulse (vacuum) hose and outlet
fuel line from the fuel pump. See Figure 8-7.
2. Remove the two hex flange mounting screws,
unhook outlet hose from blower housing clip,
and remove the fuel pump from the blower
housing.
Outlet Line
Fuel Pump
Mounting
Screws
Pulse
Hose
Figure 8-8. Blower Housing Mounting Screws.
Figure 8-9. Removing Blower Housing.
Four
Locations
Two in Front
(Not Shown)
Outer
%DIÀH
Mounting Screw
Locations
Clip