Kohler COURAGE SV710-740 - Remove Spark Plugs; Remove Valve Covers and Cylinder Heads

8.7
Section 8
Disassembly
8
)LJXUH5HPRYLQJ5HFWL¿HU5HJXODWRU
Figure 8-25. Removing Spark Plug.
Remove Valve Covers and Cylinder Heads
Plastic Valve Covers with O-rings
1. Remove the four hex flange screws securing each
valve cover. Most valve covers have the screw
hole spacers molded in place. Remove the valve
covers and O-Rings. See Figure 8-26.
3. Remove the two screws securing the rectifier-
regulator to the backing plate and disconnect the
plug. See Figure 8-23.
4. Use the tip of a small screwdriver or similar small
flat tool to bend the locking tang, then remove the
B+ (center lead) from the terminal plug as shown
in Figure 8-24. This will allow the intake manifold
to be removed with the wiring harness intact.
Plug
Figure 8-24. Removing B+ Lead from Terminal
Plug.
Remove Spark Plugs
1. Remove the spark plug from each cylinder head.
See Figure 8-25.
Figure 8-26. Removing Valve Covers.