Kohler COURAGE SV710-740 - Remove Air Cleaner and Carburetor; Remove External Governor Controls

8.4
Section 8
Disassembly
Figure 8-12. Disconnecting Linkage and Governor
Springs.
Remove External Governor Controls
1. Loosen the hex flange nut and remove the
governor lever from the cross sha. See Figure
8-13. Leave the lever aached to the throle
linkage.
Figure 8-13. Removing Governor Lever.
Remove Air Cleaner and Carburetor
WARNING: Explosive Fuel!
ȱ¢ȱȱȱȱȱȱȱȱ¢ǯȱ
ȱȱ¡¢ȱĚǰȱȱȱȱȱ¡ȱ
ȱǯȱȱȱȱȱȱȱȱ¢ȱ
from the engine.
1. Remove the two carburetor/air cleaner base
mounting nuts and disconnect the breather hose.
Remove the air cleaner base and gasket. See
Figures 8-14 and 8-15.
2. Disconnect the choke linkage from the choke
actuator lever. Unhook the governor spring, and
dampener spring from the governor lever. Note
the hole locations for reassembly. See Figure 8-12.
Figure 8-11. Control Bracket Mounting Locations.
Mounting Locations
Choke
Linkage
Dampening
Spring
Governor
Spring
Figure 8-14. Removing Mounting Nuts.
Mounting Locations