Kohler COURAGE SV710-740 - Page 44


6HFWLRQ
)XHO6\VWHPDQG*RYHUQRU
)LJXUH,QVWDOOLQJ)ORDW$VVHPEO\
12. Hold the carburetor body so the float assembly
hangs vertically and rests lightly against the
fuel inlet needle. The inlet needle should be
fully seated but the center pin of the needle (on
retainer clip end) should not be depressed. Check
the float height adjustment.
NOTE: The inlet needle center pin is spring
loaded. Make sure the float assembly
rests against the fuel inlet needle,
without depressing the center pin.
13. The correct float height adjustment is 12.0 mm
(0.472 in.) measured from the float boom to the
body of the carburetor. See Figure 5-23. Adjust
the float height by carefully bending the metal
tang of the float.
)LJXUH)ORDWDQG,QOHW1HHGOH
11. Install the float and inlet needle down into the
seat and carburetor body. Insert the new pivot
pin through the float hinge and secure with the
new retaining screw. See Figure 5-22.
)LJXUH,QVWDOOLQJ0DLQ1R]]OHDQG0DLQ-HW
9. Install the slow jet and new plug into end of slow
jet tube. See Figures 5-19 and 5-20.
)LJXUH,QVWDOOLQJ3OXJLQWR6ORZ-HW7XEH
10. Aach the inlet needle to the metal tang of the
float with the wire clip. The formed 90° lip of the
metal tang should point up, with the needle valve
hanging down. See Figure 5-21.
)LJXUH,QVWDOOLQJ6ORZ-HW