CARTRIDGE
FIGURE
2
-
2
--
K662
CARTRIDGE TYPE
OIL
FILTER
Remote Mount Oil Filters:
The remote mount filter can be serviced as the lube oil is drained from the
engine.
No special tools are required for this type of filter.
The following procedure is used for
replacing element:
1.
Drain oil through plug provided on filter body.
2.
Remove screw securing cover to the filter body, then remove cover.
3.
Grasp clip on top
of
filter element and pull element out of filter body
-
-
slip pan or rag under
element as
it
is removed to prevent oil from dripping on engine.
Discard old element.
4.
Thoroughly clean inside of cover and body
--
make sure all trace of dirty oil is removed.
Replace cover gaskets if needed.
Close drain plug after cleaning.
5.
Slip new element (make
sure
proper replacement element
is
used) then position and secure
cover
with retaining screw.
Remember to add one quart of oil for filter capacity.
To Next Page
Loading...
Need help?
General
