EasyManuals Logo

Kohler K532 User Manual

Kohler K532
91 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #13 background imageLoading...
Page #13 background image
3.
After every
50
hours of operation remove retaining bar and remove element for thorough
cleaning.
Since element must be allowed to drip dry after washing, keep extra element
on
hand to prevent down time during the drying period.
Wash element as follows:
(A)
Swish element briskly in warm water containing a non
-
sudsing detergent.
DO
NOT
WASH
IN
ANY
OTHER
SOLUTION
OR
WITH HOT WATER.
(B)
Direct gentle stream of clean water into inside of element to reverse flush element.
Rinse thorou
g
hl
y
.
(C)
Shake out excess water then place element on end in clean area
--
allow element to
air dry.
CAUTION: DO NOT
use compressed air to speed up drying process as this
will rupture filter material.
(D)
After element is
dry,
insert flashlight inside element.
An
even fine pattern of light
as observed through the
filte'r material indicates element is clean and ready for
re
-
use. If a large spot
of
light is observed, element is ruptured and must be
replaced.
Before installing serviced element, wipe out inside of filter body. Inspect gasket end of element
-
-
replace element if gasket is damaged or missing. Element should be replaced after
10
washings or
after one year of use.
Also replace automatic dust unloader after one year of use.
OIL
BATH TYPE
AIR
CLEANERS
Oil bath air cleaners are often used where above normal concentration
of
dust, lint,
chaff, etc.
is
present. Normally, the oil bath cleaner should be serviced after every
25
hours of operation; how
-
ever,
if extremely dusty or dirty conditions exist, service cleaner more frequently
-
-
even every
8
hours or twice daily
if
conditions warrant this.
There are several different types of oil bath air cleaners in use.
On most, outside air is drawn
in through a screen or rain cap and is then pulled across a pool of oil which absorbs the heavier
particles.
The partially cleaned air
is
then drawn through an oil laden filter element for final filtering
and then into the carburetor.
On some, a series of elements with varying degrees of filtration quali
-
ties are used for final filtering.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Kohler K532 and is the answer not in the manual?

Kohler K532 Specifications

General IconGeneral
Compression Ratio8.5:1
Cooling SystemAir-cooled
Fuel TypeGasoline
Ignition SystemElectronic
Starting SystemElectric start
Displacement532 cc
Horsepower18 HP

Related product manuals