Service and Repair Manual Repair
Exhaust gas system
3.8.3 Turbocharger removal and installation (SL 233)
Previous tasks
q Drain LT coolant water.
q Remove turbocharger cooling lines. (For more information see: Previous tasks, page 203.)
Specific safety instructions
WARNING
Hazards by hot engine near operating temperature.
Any contact with hot surfaces could result in death or serious injuries by burns.
The engine control unit (ECU) is hot while operating the engine.
u Avoid any contact with the engine, parts carrying hot coolant or oil, the exhaust system, the
turbocharger, the heat protection, the battery, the covers, and the ECU.
u Proceed with the tasks on the engine only once the temperature has cooled down enough so
that surfaces can be touched with bare hands.
NOTICE
Risk of property damage by reuse of sealing.
Leakage by faulty seal.
u Replace all sealings.
Special tools
Not applicable.
Consumables and equipment
– Hot temperature grease
– Rags
– Cleaner
KD62V12 33525088601_7_1 EN_US
2021-07
© 2021 by Kohler Co. All rights reserved.
165
To Next Page
Loading...
Need help?
General
