Kohler KD62V12

Service and Repair Manual Repair
Lubricating system
Installation
u Clean sealing area.
u Lubricate filter seal 3 with engine oil.
u Screw spin-on oil filter 1 in filter head 2 until it contacts base.
u Tighten filter by hand by 1/2 turn.
Specific values
Not applicable.
Tightening specifications
Refer to standard tightening torques.
(For more information see: 5.3 Standard tightening torques,
page 264.)
3.9.4 Prelubricating pump removal and installation (depending on
application)
Previous tasks
q Drain engine oil.
Specific safety instructions
Not applicable.
Special tools
Not applicable.
Consumables and equipment
– Rags
KD62V12 33525088601_7_1 EN_US
2021-07
© 2021 by Kohler Co. All rights reserved.
193