Operation and Maintenance Manual Safety
Operating and maintenance areas
2.8 Operating and maintenance areas
Before first start-up, the manufacturer of the machinery shall respect and enforce following safety
and health instructions:
DANGER
Entanglement, trapping, ejection of parts or impact hazards!
Fatal or serious injuries.
u The engine shall not be started until the drive train has been connected to the flywheel.
u Ensure the integrity of the machine and the engine before starting.
u All openings must be closed and the safe conditions established by the manufacturer of the
machinery must be fulfilled.
u Standing in the vicinity of the engine while starting or operating the manufacturer’s machinery is
forbidden.
2.8.1 Engine ready for use or in operation
Fig. 33: Engine areas in operation — view from above and flywheel side
It is forbidden to access to following areas:
– A – Engine front (damper side)
– B – Engine sides
– C – Engine rear (flywheel side)
– D – Above the engine
– E – Below the engine
KD83V16 33521030601_0_1 EN_US
2018-07
© 2018 by Kohler Co. All rights reserved.
45
To Next Page
Loading...
