6
_07
31
A
F
C
B
A
B
G
B
B
E
D
C
6.7
6.8
6.9
EN
INFORMATION ABOUT REPLACEMENTS
6.3 Filter cartridge and fuel pre-filter check
NOTE: The fuel filter is situated on the
crankcase of the engine or it may be
assembled on the frame of the vehicle.
1. Disconnect the cable A of the water presence sensor C.
2. Remove the water presence sensor C from its cartridge B.
3. Loosen the cartridge B using the appropriate wrench
(Fig. 6.9).
4. Lubricate the gasket D of the new cartridge B.
Important
• Do not fill the new cartridge B with fuel.
5. Tighten the new empty cartridge B (Fig. 6.9) on the diesel
fuel filter support E using the special wrench (tightening
torque of 17 Nm).
6. Tighten the water presence sensor C on the new cartridge
B (tightening torque of 5 Nm).
7. Reconnect the cable A of the water presence sensor C.
NOTE: Bleeding.
8. Push repeatedly the button G in order to fill the circuit.
6.4 Air filter cartridge replacement
NOTE: Component not supplied by KOHLER.
Refer to the technical documentation of the vehicle.
5. Fit and tighten the cover A on the oil filter support F,
tightening it with a torque wrench G (tightening torque of
25 Nm).
ED0053030050
To Next Page
Loading...
Need help?
General